D-Link DWC-1000

D-Link DWC-1000 User Manual 267
Section 7 - VPN
SSL VPN
SSL VPN Policies can be created on a Global, Group, or User level. User level policies take precedence over Group
level policies, and Group level policies take precedence over Global policies. These policies can be applied to
a specic network resource, IP address, or IP ranges on the LAN, or to dierent SSL VPN services supported by
the switch. The List of Available Policies can be ltered based on whether it applies to a user, group, or all users
(global).
To add a SSL VPN policy, you must rst assign it to a user, group, or make it global (i.e., applicable to all SSL VPN
users). If the policy is for a group, the available congured groups are shown in a drop-down menu and one
must be selected. Similarly, for a user-dened policy, a SSL VPN user must be chosen from the available list of
congured users.
The next step is to dene the policy details. The policy name is a unique identier for this rule. The policy can
be assigned to a specic Network Resource (details follow in the subsequent section), IP address, IP network,
or all devices on the LAN of the switch. Based on the selection of one of these four options, the appropriate
conguration elds are required (i.e., choosing the network resources from a list of dened resources, or dening
the IP addresses). For applying the policy to the addresses, port range/port number can be dened.
The nal steps require the policy permission to be set to either permit or deny access to the selected addresses
or network resources. Also, the policy can be specied for one or all of the supported SSL VPN services (i.e., VPN
tunnel).
Once dened, the policy goes into eect immediately. The policy name, SSL service it applies to, destination
(network resource or IP addresses), and permission (deny/permit) is outlined in a list of congured policies for
the controller.
Note: You must enable Remote Management. Refer to “VLANs” on page 171.
To create a new SSL VPN policy:
1. Make sure you have enabled remote management and have created user(s) and group(s) to assign to
this policy.
2. Click VPN > SSL VPN > SSL VPN Server Policy. Next to SSL VPN Server Policy, toggle to On and click
Save.
3. Click Add New SSL VPN Server Policy.
Server Policies