D-Link DWC-1000 User Manual 356
Section 9 - Maintenance
Soft Reboot
Restoring Factory Default Settings
Path: Maintenance > Firmware > Soft Reboot
If you reset a wireless controller to its factory default settings, it returns to the state when it was new — all
changes you made to the default conguration are lost. Examples of settings that get restored include, critical
things you need to get online, such as login password, SSID, IP addresses, and wireless security keys.
There are two ways to restore a wireless controller to its original factory default settings:
• Use the reset button on the back of the wireless controller (see “Using the Reset Button to Restore
Default Settings” on page 368).
• Use the web management interface instructions below.
1. Click Maintenance > Firmware > Soft Reboot.
2. Next to Factory Default settings, click the Default button.
3. At the conrmation message, click OK to restore factory default settings; or click Cancel to retain your
current settings.
Note: After restoring the factory default conguration, the wireless controller’s default LAN IP address is 192.168.10.1,
the default login user name is admin, and the default login password is admin.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
