D-Link DWC-1000

D-Link DWC-1000 User Manual 140
DHCP Address Pool
Path: Network > LAN > LAN Settings
Upon enabling DHCP, you can dene a set of IP ranges (referred to as “pools”). Each LAN on the controller can be
sub-divided into 8 pools. The subnet and network of each pool must be within that of the LAN, congured on
the LAN Settings page. Most importantly, pool IP address must not overlap on another.
New LAN DHCP clients will be assigned IP addresses starting with the “Start” IP address in the rst pool in the list
of pools. Clients will continue to receive sequential IP addresses until the “End” IP address of the rst pool. Then,
if further pools are congured, the next LAN client to join the domain of this controller will receive the “Start” IP
address of the second congured pool, and so on.
1. Go to Network > LAN > LAN Settings page.
2. Click Add New Pool.
3. Fill-in the following details:
• Start IP: Displays Start IP address of the LAN DHCP Pool.
• End IP: Displays End IP address of the LAN DHCP Pool.