D-Link DWC-1000 User Manual 346
Section 8 - Security
Field Description
Enable Remote Management
By default, Remote management over the internet is disabled. Click
ON/OFF button to enable authorized users to access this GUI over the
internet.
HTTPS Port Number
You can set the port number for remote management over HTTPS; the
default is 4443.
SSH
By default, SSH over the internet is disabled. Click ON/OFF button to
enable authorized users to access this CLI over the internet.
SNMP Switch it ON to access the device through SNMP remotely.
Access Type
Permission for Remote Management can be given to a selected PC, a
range of IP addresses, or anyone on the Option or LAN.
Respond to Ping
To congure the controller to respond to an ICMP Echo (ping) packet
coming from the Option side, switch it to ON. This setting is usually
used as a diagnostic tool for connectivity problems. It is recommend-
ed that the option be OFF at other times to prevent hackers from
easily discovering the controller through a ping .
To Next Page
Loading...
