D-Link DWC-1000 - Page 237

D-Link DWC-1000 User Manual 237
Section 8 - Security
3. Complete the elds from the table below and click Save.
Field Description
From Zone
Select the source of originating trac: either secure LAN, public DMZ, or insecure Option.
For an inbound rule Option should be selected.
To Zone
Select the destination of trac covered by this rule. If the From Zone is the Option, the To
Zone can be the public DMZ or secure LAN. Similarly if the From Zone is the LAN, then the
To Zone can be the public DMZ or insecure Option.
Service Select a service from the drop-down menu. ANY means all trac is aected by this rule.
Action Select an action from the drop-down menu.
Source Hosts
Select a source host. If you select Single Address or Address Range, you will need to enter
the IP address or IP range.
Destination Hosts
Select a Destination host. If you select Single Address or Address Range, you will need to
enter the IP address or IP range.
Log Select whether to log rewall trac or not.
QoS Priority (IPv4 only)
Outbound rules (where To Zone = insecure Option only) can have the trac marked with a
QoS priority tag. Select a priority level:
• Normal-Service: ToS=0 (lowest QoS)
• Minimize-Cost: ToS=1
• Maximize-Reliability: ToS=2
• Maximize-Throughput: ToS=4
• Minimize-Delay: ToS=16