D-Link DWC-1000 User Manual 359
Section 9 - Maintenance
To use a USB drive to update the rmware, click the Using USB tab.
2. If the rmware version on the D-Link Support website has a higher number than the rmware version
shown under Firmware Information, continue with this procedure.
3. Download the new rmware from the D-Link website.
4. Under Firmware Upgrade, click the Choose File button.
5. In the Browse Firmware dialog box, navigate to the rmware le, click the le, and then click Open. If
you want to upgrade using a le from a USB drive, click the Using USB tab near the top of this page.
6. Click Upgrade.
7. At the conrmation message, click OK to start the rmware upgrade. A progress bar shows the progress
of the upgrade.
Note: The upgrade process takes a few minutes. Do not interrupt the upgrade or turn o the system;
otherwise, you can damage the rmware. Wait for the upgrade to complete before browsing any sites from
your browser.
8. When the upgrade completes, log in to the wireless controller web management interface, click
Maintenance > Firmware > Firmware Upgrade, and conrm that the new rmware appears next to
Firmware on the Using System (PC) page.
9. Record the rmware level in Appendix A.