D-Link DWC-1000 User Manual 382
Section 10 - Troubleshooting
Authentication with SMTP
Server
If E-Mail Logs is enabled, select an authentication if the SMTP server requires
authentication before accepting connections. Choices are:
• None = no authentication is used. The User Name and Password elds are not
available.
• Login Plain = authentication used to log in using Base64-encoded passwords
over non-encrypted communication session. Base64-encoded passwords oer
no cryptographic protection, making them vulnerable.
• CRAM-MD5 = a challenge-response authentication mechanism dened in RFC
2195 based on the HMAC-MD5 MAC algorithm. CRAM-MD5 oers a higher level
of authentication than Login Plain.
Field Description
User Name
If Authentication with SMTP Server is set to Login Plain or CRAM-MD5, enter the user
name to be used for authentication.
Enable Tls
If the SMTP server requires Tls support to sent logs through emails, then this option
should be enabled, and this eld is available only for authentication methods Plain
Login or CRAM-MD5.
Password
If Authentication with SMTP Server is set to Plain Login or CRAM-MD5, enter the
case-sensitive password to be used for authentication.
Respond to Identd from SMTP
If E-Mail Logs is enabled, this option determines whether the wireless controller
responds to IDENT requests from the SMTP server. Choices are:
• ON = wireless controller responds to an IDENT request from the SMTP server.
• OFF = wireless controller ignores IDENT requests from the SMTP server.
Send E-Mail Logs by Schedule
To receive e-mail logs according to a schedule, congure the appropriate schedule settings. Scheduling options are
enabled when the Enable E-Mail Logs option is checked.
Unit
Select the period of time that you need to send the log. This option is useful when you
do not want to receive logs by e-mail, but want to keep e-mail options congured,
so you can use the Send Log function Event Log viewer pages. Choices are:
• Never = disable sending of logs.
• Hourly = send logs every hour.
• Daily = send logs every day at the specic time.
• Weekly = send logs weekly, at the Day and Time specied.
Day If Unit is set to Weekly, select the day when logs will be sent.
Time If Unit is set to Daily or Weekly, select the time when logs will be sent.