D-Link DWC-1000

D-Link DWC-1000 User Manual 75
Section 4 - Advanced WLAN Conguration
4. Go to Wireless > ACL > IP ACL Rules page, select the IP ACL ID from the IP ACL drop down list.
5. Click Add New Rule to add an IP ACL Rule, i.e. rule 1, to block the ICMP trac from STA1 and STA2.
6. Repeat step 5 to add another rule to block the ICMP trac from STA2 to STA1.
7. After conguring all the rules, add one permit rule. Adding a permit rule is mandatory to allow all other
types of trac to ow between the source and destination, as in an AP, there is an implicit “deny all” rule
at the end of ACL.