152 of 282 M-SV-001-EN Rev. G
Figure 4-174 SCR Cooling Manifold Removal
NOTE
"Figure 4-174 SCR Cooling Manifold Removal" illustrates a TTS350 compressor. The removal and installation process for TTH/TGH
compressors is the same, with the exception of the SCR Temperature Sensor as that is not used on the TTH/TGH compressors.
4.20.4 SCR Cooling Manifold Installation - TTS300/TGS230
1. Clean O-ring groove in the main compressor housing.
2. Apply O-Lube to the Inverter O-ring and place the O-ring in the compressor housing groove.
3. Apply O-Lube to the O-rings and install them into the SCR cooling manifold. Refer to "Figure
4-175 SCR Cooling Plate O-ring Installation - TTS300/TGS230".
Figure 4-175 SCR Cooling Plate O-ring Installation - TTS300/TGS230
4. Install the SCR Cooling Manifold to the Inverter Cooling Manifold using the two (2) M6x20
fasteners. Torque to 7 Nm (62 in.lb.).
5. Secure the insulation onto the backside of the SCR Cooling Manifold.
6. Install the Inverter.
NOTE
It is recommended that the new fasteners supplied with the kit be used to ensure to ensure proper torque is obtained.
7. If the SCRs were removed previously, install the SCRs to the SCR cooling manifold. Torque the
TTS350 Revision F SCR
Cooling Manifold Shown
SCR Manifold
Return Brass
Fitting
SCR Cooling
Manifold
Fasteners,
M6x35
(4 places)
SCR Cooling
Manifold O-rings
(2 places)
To Next Page
Loading...
Need help?
General
