60 of 282 M-SV-001-EN Rev. G
Figure 4-13 Relief Membrane Position
Figure 4-14 Recessed Holes
5. Place the long M5x20 fastener and flat washer in position number three (3) shown in "Figure
4-15 Capacitor Cover Torque Sequence". Use the remaining M5x15 fasteners to secure the
cover. Tighten all fasteners according to the sequence in "Figure 4-15 Capacitor Cover Torque
Sequence". Torque to 13 in.lb. on the second pass.
Figure 4-15 Capacitor Cover Torque Sequence
4.2.5 Compressor Cover Torque Specifications
Table 4-6 Compressor Cover Torque Specifications
Relief membrane
should be visible
when Capacitor
Cover is installed
Capacitor Cover
Fastener,
M5x20
Capacitor Cover
Fastener,
M5x15
(5 places)
1
5
3
2
4
6
Description Nm Ft.Lb. In.Lb.
Cover Fastener, M5x15 1.5 - 13
Cover Fastener, M5x20 (#3 on Capacitor Cover) 1.5 - 13
To Next Page
Loading...
