EasyManuals Logo
Home>Danfoss>Compressor>Turbocor TTS Series

Danfoss Turbocor TTS Series User Manual

Danfoss Turbocor TTS Series
282 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #269 background imageLoading...
Page #269 background image
269 of 282
M-SV-001-EN Rev. G
Appendix A – Acronyms/Terms
Table A-1 Acronyms/Terms
Acronym / Term Definition
AC Alternating Current
AFT Ascending fault triggering
Alarms
Alarms indicate a condition at the limit of the normal operating envelope. Compressor alarms will still allow the
Compressor to run, but speed is reduced to bring the alarm condition under the alarm limit.
ASHRAE
American Society of Heating Refrigeration and Air-Conditioning Engineers
(www.ashrae.org).
Backplane A PCB for the purpose of power and control signal transmission. Many other components connect to this board.
BMCC
Bearing Motor Compressor Controller. The BMCC is the central processor board of the Compressor. Based on its
sensor inputs, it controls the bearing and motor system and maintains Compressor control within the operating
limits.
Cavity Sensor
NTC temperature sensor located behind the Backplane for the purpose of sensing motor-cooling vapor
temperature. Provides overheat protection to motor windings.
CE
CE marking ensures the free movement within the European market of products that conform to the
requirements of EU legislation (e.g., safety, health and environmental protection and is a key indicator of a
product’s compliance with legislation.
The CE marking is affixed by manufacturers to their products. By placing CE marking on a product, manufacturers
declare on their sole responsibility that the products comply with all the legal requirements in force in Europe.
Citation: European Commission; Directorate-General for Enterprise and Industry; ww.ec.europa.eu/CEmarking.
CIM / I/O-board
Compressor Interface Module; the part of the compressor electronics where the user connects all field connection
wiring such as
RS-485, EXV, and analog / digital wiring. Also known as the I/O board.
DC Direct Current
DC-DC DC to DC Converter
DFT Descending fault triggering
DIN German Institute for Standardization
EEPROM Electrically Erasable Programmable Read-Only Memory
EMF Electromotive Force
EPR Evaporator pressure regulating
ESD Electostatic Discharge
EXV Electronic Expansion Valve
HV High Voltage
IGV Inlet guide vane
INS Instant fault triggering
I/O Input/output
kV Kilovolt
LED Light Emitting Diode
LOTO Lockout/Tagout
NTC Negative Temperature Coefficient
OEM Original Equipment Manufacturer
ORFS O-ring face seal
PCB Printed circuit board
PDF Portable Document Format
PWM Pulsse width modulation
P/T Pressure/Temperature
RFT Range fault triggering
SCR Silicon Rectifier Diode

Table of Contents

Other manuals for Danfoss Turbocor TTS Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Danfoss Turbocor TTS Series and is the answer not in the manual?

Danfoss Turbocor TTS Series Specifications

General IconGeneral
BrandDanfoss
ModelTurbocor TTS Series
CategoryCompressor
LanguageEnglish

Related product manuals