61 of 282
M-SV-001-EN Rev. G
4.3 Cooling Adapter
To provide cooling for the motor and power electronics, a liquid feed line is connected to the
compressor via the Cooling Adapter. This adapter contains a strainer to collect any debris that may be
present.
Figure 4-16 Cooling Adapter - Excludes TTH375/TGH285
Figure 4-17 Cooling Adapter - TTH375/TGH285)
• • • CAUTION • • •
A filter/drier must be used in conjunction with the Cooling Adapter strainer is not a replacement. The strainer is used as a backup
to prevent damage to the solenoid orifices should any debris get past the filter/drier.
Nut
Inside thread 13/16
UN-2A
11 Nm (8 ft.lb.)
Braze Sleeve
Strainer
O-ring
Adapter Body
Connection thread
M16x1.5
25 Nm (18 ft.lb.)
O-ring
Nut
Inside thread 13/16
UN-2A
11 Nm (8 ft.lb.)
Braze Sleeve
Strainer
O-ring
Adapter Body
Connection thread
M16x1.5
25 Nm (18 ft.lb.)
O-ring
To Next Page
Loading...
