Dasan V8102 - Page 791

User Manual UMN:CLI
V8102
791
able} [ONU_IDs]
[GPON]
the OLT port.
In order to apply the auto upgrade for ONU, you should enable the configured auto up-
grade on the specific OLT port by onu auto-upgrade enable command on GPON Inter-
face Configuration mode.
To perform the auto upgrade of OLT firmware when the version of two firmware is differ-
ent, regardless of the lastest firmware version, use the following command.
Command
Mode
Description
onu auto-upgrade version-
match all { enable | disable}
Interface
[GPON]
Enables/disables the ONU auto upgrade function with-
out verification of the firmware version.
(6) Displaying Auto-upgrade Configuration
To display the ONU auto upgrade configuration, use the following command.
Command
Mode
Description
show onu auto-upgrade info
Enable
Global
Shows a progress of ONU auto-upgrade.
show onu auto-upgrade model-
list gpon OLT-ID [NAME]
Shows a list of ONU model names configured to be
auto-upgraded.
NAME: ONU model name
show onu auto-upgrade model-
list [NAME]
Interface
[GPON]
To display the firmware for ONU auto-upgrade, use the following command.
Command
Mode
Description
show onu auto-upgrade firm-
ware [info]
Enable
Global
Shows the firmware information of auto-upgraded
ONU.
The following is an example of displaying the firmware for ONU auto-upgrade.
SWITCH(config-if[GPON1/1])# show onu auto-upgrade current-fw
Current Firmware : G_ONU_DALLAS_22_0_8_33.bin
SWITCH(config)# show onu auto-upgrade firmware
---------------------------------------------------------------------------------
Model | Firmware Name | Version | Status
---------------------------------------------------------------------------------
H645 | G_ONU_DALLAS_22_0_8_33.bin | 22.1.8.33 | Download Complete
To display the status of ONU firmware, use the following command.
Command
Mode
Description
show onu firmware version
gpon OLT-ID [ONU-IDs]
Enable
Global
Shows the status of ONU firmware.
OLT-ID: GPON port number
ONU-ID: ONU ID (1-128) or ONU serial number
i