RECOMMENDED MAINTENANCE FREQUENCY
PRODUCT REFERENCE GUIDE
303
RECOMMENDED MAINTENANCE FREQUENCY
The AV500/AV900 Camera System is designed for industrial environments. The recom-
mended frequency for performing these maintenance tasks will depend on the applica-
tion’s environment. In general, these procedures are recommended only if it is noticed
that the
environment is dirty enough that deposits are appearing on the equipment or
when performance is degraded by accumulation of dust or dirt on the exit windows or
deflection mirrors. By monitoring normal operations and performing weekly visual
checks, you can establish a maintenance schedule that fits your application.
MAINTENANCE TASKS
Perform the maintenance tasks on an “as needed” basis to assure proper operation of
the camera.
Task schedule frequency depends upon the application environment conditions. Harsh
enviro
nments that expose the equipment to more heat, dust, and dirt will require these
procedures be performed more frequently.
It only requires a few minutes to complete each maintenance task.
Exterior Cleaning
The exterior cleaning procedure may be performed without removing the camera from
the mounting structure.
1. Switch off the conveyor.
2. Switch off the camera system by disconnecting the power source.
3. Clean the exterior (except the windows) with a clean, soft-bristle brush. Be sure
not to
brush any dust, dirt, or debris onto the windows.
4. Carefully remove any dirt or debris in or around the connector panel.
5. Wipe the exterior with a clean, soft cloth dampened slightly with a mild detergent
solution.
Cleaning the Illumination / Camera Window
Do not use any chemical on the camera that is unsafe for plastics, such as benzene, acetone,
or similar products. Before performing this maintenance task, be sure to shut down the unit.
Shut down the camera system before performing this maintenance task. Do not stare into
the camera’s window at the LED light. Avoid direct eye exposure. The LED light level does
not constitute a health hazard, however staring at the LED light for prolonged periods could
result in eye damage.
Never apply cleaning solution directly to the camera window. Always apply the solution to a
cloth, and then the cloth to the window. Do not use any chemical on the camera that is
unsafe for plastics, such as benzene, acetone, or similar products.
To Next Page
Loading...
Need help?
General
