xvi
AV500/AV900 2D CAMERA
COMPLIANCE
Laser Safety
This product conforms to the applicable requirements of IEC60825-1 (Ed. 3). and com-
plies with 21 CFR 10 except for deviations pursuant to laser notice N° 56, date January
19, 2018. This product is
classified as a Class 2 laser product according to IEC 60825-1
regulations. The targeting lasers are pulsed 416Hz with a 400us on time which results in
a 16.67% duty cycle with an angular subtense of 1.5mRad. Average power is less than
1.0mW.
Electrical Safety
This product conforms to the applicable requirements contained in the European Stan-
dard for electrical safety EN 60950-1:2006 +
A11:2009 + A1:2010 + A12:2011 +
A2:2013 at the date of manufacture.
Caution
Use of controls or adjustments or performance of procedures other than those specified
herein may result in exposure to hazardous visible laser light.
Disconnect the power supply when opening the device during maintenance or installa-
tion to avoid exposure to hazardous laser light. The laser beams are intended for initial
alig
nment and positionin
g.
LED SAFETY
These camera bar code readers include illumination that use high powered light emit-
ting diodes (LEDs). LED emission accor
ding to IEC 62471, Risk Group 0.
White Light Illuminations
RISK GROUP 0 LED emission according to IEC 62471.
Disconnect the power supply when opening the device during maintenance or installa-
tion to avoid exposure to LED light. The LED can be switched on or off through a soft-
ware command.
Power Supply
This product is intended to be installed by Qualified Personnel only.
This product is intended to be supplied with a UL listed or CSA Certified LPS Power unit
of 24 volt,
2 amp minimum (24 VDC Nominal, +/-20%).
CE Compliance
CE marking states the compliance of the product with essential requirements listed in
the applicable European directive. Since the directives and applicable standards are
To Next Page
Loading...
Need help?
General
