DIAGNOSTICS | LOG VIEWER
PRODUCT REFERENCE GUIDE
243
Diagnostics | Log Viewer
Use the Log Viewer (Decoder) window to view encoder/tachometer and trigger event
information.
To access the Log Viewer (Decoder) window:
1. In the menu tree under Diagnostics, click Log Viewer (Decoder). The Log Viewer
(Decoder) window opens.
2. Click Connect to view logg
ed data from the decoder, the information posted on
the Log Viewer window.
3. Click Disconnect to pause the da
ta stream.
The log view data will only post the data associated with the camera that the GUI inter-
face is connected to. It does not post data from other camera's in the tunnel.
Contact Datalogic Tech Support to review diagnostic information.
Click Reset to re-enable Verbose Mode logging.
To Next Page
Loading...
Need help?
General
