ADVANCED DECODE
PRODUCT REFERENCE GUIDE
137
Advanced Decode
Advanced Decode provides ways to improve read rate, by setting filters or more precise
parameters, however these settings often affect processing time. When you set
Advanced Decode parameters there is a fine balance between reading performance and
processing time. Use Advanced Decode options with caution.
To edit the Advanced Decode Settings:
1. In the menu tree under Modify Settings, navi
gate to Global Settings | Advanced
Decode. The Advanced Decode window opens.
2. Enter the appropriate information in the form as described below:
Min distance between frames in a trigger (For PackTrack only)
Enter the minimum distance between frames required per trigger cycle.
Filter Overlapping Duplicate Codes
Select the Check box to enable the camera to filter out duplicates where the bounding boxes
overlap. The bounding box is the area that a bar code is found in by the decode engine.
Enable Low Profile 1D Codes
Select the check box to enable reading of low profile 1D barcodes. This option is used when
the bar height of the 1D is small (1/4 inch (6.4mm). It causes the decode engine to spend more
time looking at the bar code in the image.
Enable Low Contrast Improvements
Select the check box to enable automatic contrast improvements.
Enable High Resolution Codes
Select the check box to enable High Resolution Codes.
It is best to use Advanced Decode only when necessary and under the guidance of Data-
logic Tech Support.
This option may increase processing time which may create no reads
To Next Page
Loading...
Need help?
General
