Dexcom G5 - Removing Applicator and Collar

Dexcom G5 Mobile System User Guide
82Starting a Sensor Session: Inserting Sensor, Attaching Transmitter, and Starting Your Session
(Continued from previous page)
Removing Applicator and Collar
10
Move two fingers from above collar to below collar.
Keeping your thumb as a base on the white plunger.
Pull back collar all the way towards your thumb.
You should hear 2 clicks.
NOTE: Finger placement is important for correct
needle removal.
11
Hold transmitter latch down against your body.
Squeeze ribbed release tabs on the sides of sensor
pod.
12a
Move applicator barrel forward and out, away from
your body.
Follow local ordinances when disposing of the
applicator.
12b
What’s left?
1. Sensor pod
2. Transmitter latch
You have successfully inserted the sensor!
At this point, you should have two items attached:
1. Sensor pod
2. Transmitter latch