Chapter 4 -Operational Procedures-
112
AS-410M Auto Slide Preparation System
⑤ Sample selection of each tray is available with the AUTO mode and with the 96-block feeding
system. Systems with 6-block and 24-block feeding are not indicated on the screen.)
Select one or more trays, then touch the NEXT button.
To change the start position for each tray, press the SELECT START SAMPLE button and enter the
start position number.
⑥ Block option (AUTO mode)
With the AUTO mode, the system checks the sample block from the smallest number on the tray.
If the next two block numbers are empty (without two blocks), the block(s) after the two skipped
spaces will not be sliced.
Tray check screen of the AUTO
mode: System with 96-block
feeding (e.g. selecting Trays 1
and 2)
Tray 4
No.73 to 96
Tray 1
No.1 to 24
Tray 2
No.25 to 48
Tray 3
No.49 to 72
2 empty blocks
Only block No. 1 to 3 will be sliced.
3 blocks set
Confirmation screen with the 96-block feeding
unit. (Selecting the sample block to start)
To Next Page
Loading...
Need help?
General