DNS AS-410M User Manual

Chapter 4 - Operational Procedures -
AS-410M Auto Slide Preparation System 147
If the ID is longer than 16 half width characters, it can be divided into 2 lines to print.
Press ID area to input information in two lines while lit. When ID information uses 2 lines choose
DATE & TIME or INSTITUTE name for the bottom line.
<How to add a line when printing on two lines>
① During the setting for two-line printing, when the ID area is pressed down and held, a sub screen
for two-line printing settings will be displayed.
② Items that can be displayed for 2-line printing
The line break position can be changed as indicated in the chart below. The possible settings at
the line break position and the position that can be selected for the start of a new line are also
explained.
Line break position Items that can be set Selecting the starting
position of the line
1 Line break at the right end ― ―
2
Specify with the number of
characters from the
beginning
Enter the number of
characters from the
beginning
―
3
Specify with the number of
characters from the end
Enter the number of
characters from the end
―
4
Add a line break to the
specified characters
Enter the characters which
a line should be added
Upper line
Lower line
Delete
Offline print setting screen
(ID in 2 lines with DATE & TIME)
Offline print setting screen
(ID in 1 line)
Offline print setting screen
(ID in 2 lines with INSTITUTE name)
Offline print setting
screen (ID in 2 lines with
Date & Time)
Screen for offline print setting
(display of print setting screen for 2 lines)

DNS AS-410M Specifications

General

Brand	DNS
Model	AS-410M
Category	Industrial Equipment
Language	English