Precautions
If puncture is found, please read the following
safety instructions for safe and correct
emergency tire repair.
Wear gloves and take appropriate protecting
measures before operation to prevent injury.
● The emergency tire repair tools are only
suitable for sealed tires with puncture on
the tread.
● Make sure the vehicle is parked reliably
and the shift lever is at “P” position.
● Tire valve damage or sidewall damage is
out of the repair scope.
● If there is heavy traffic on the road and it
is in close proximity to the faulty vehicle,
contact the roadside service instead of
repairing the wheel.
● The diameter of the puncture to be
repaired should be not more than 6mm.
● After the tire sealer is applied, the vehicle
speed should not exceed 80km/h.
● If the tire sealer is splashed on a tire or
rim during use, rinse it with clean water or
wipe it with a rag. If the tire sealer is
splashed into an eye accidentally,
immediately rinse the eye with clean
water.
● The storage temperature is -40°C~85°C.
Contact with an open flame is prohibited.
Preparations
Preparing to stop
If you find that a tire is pinned or punctured by
foreign objects and the diameter of the puncture
is less than or equal to 6mm, drive the vehicle
slowly to a safe place for emergency tire repair.
The following points should be noted:
1. Turn on the hazard warning lamp;
2. Drive the vehicle slowly, and keep it away
from the highway and traffic;
3. Apply the EPB;
4. Set the shift lever to the “P” position;
5. Set the ENGINE START/STOP button to OFF
position;
6. Place the warning triangle at a suitable
position which is at the specified distance from
the rear of the vehicle.
To Next Page
Loading...