Selecting sunshade film*
Violet: UV light
Blue: Visible light
Red: Infrared light
The main purpose of applying sunshade film on
the window is to reduce UV and IR in the vehicle
while ensuring better visibility and privacy for the
vehicle.
Choose a sunshade film with high reflectivity
from UV to IR and high transmittance to visible
light, i.e., a high-definition sunshade film.
Don't pay too much attention to sun
protection, heat insulation and privacy. Make
sure that the light transmittance (i.e., the
transmittance of sunshade film × the
transmittance of window glass) is not lower
than 70% when the sunshade film has been
applied; otherwise, it will reduce the driver's
visibility, thus largely degrading driving
safety.
Vehicle corrosion protection
Frequently wash and wax the vehicle to keep it
clean. The anti-freezing agent and snow-melting
agent sprayed on roads are corrosive, hence the
underbody should be rinsed immediately after
the vehicle has run on such roads.
Regularly check for minor paintwork damage
and repair in time.
Check the underbody for accumulation of sands,
dirt or saline matter, and if any, rinse it with
water immediately.
Other special requirements may be specified for
rust and corrosion prevention in some regions,
and please consult an authorized dealer.
● Never use water to directly rinse off the
dirt, sands and other scraps accumulated
in the passenger compartment, but use a
vacuum cleaner or a broom.
● Do not let water or other fluids contact
interior electrical components, or the
electrical components will get damaged.
To Next Page
Loading...