● The width between two reversing auxiliary
lines is larger than the actual vehicle
width.
● The rear view static auxiliary lines will
slightly deflect rightwards because the
reverse camera is not installed in the
middle.
● The positions of the auxiliary lines
displayed on the screen will vary with the
vehicle load (number of passengers,
luggage weight, etc.). Be sure to visually
check the vehicle surroundings before the
operation.
● Due to the vision disparity of each person,
the movement of the vehicle and different
shapes of obstacles, the distance seen
visually on the display may be different
from the actual distance.
● During reversing from flat ground toward
uphill, the actual distance to the obstacle
is shorter than that seen on the display.
Be careful not to hit objects in the
reversing track during reversing.
Due to the limited monitoring range, the
areas underneath the bumper, near the
rear of the bumper and at both bumper
corners cannot be displayed on the
screen.
Operation instructions of reverse camera
When being activated, the reverse camera
system is required to be initialized for some time,
during which the image shown on the display
may be not true.
When the temperature is too high/low or the light
is too bright/dark, the display may not be able to
show the object clearly, which shall not be
considered as a fault.
Shadow of an object may be shown on the
display. This is due to the reflection of This is not
a fault, but is caused by the sunlight reflection of
bumper.
Screen may flash under fluorescence, which
shall not be considered as a fault.
The color of object shown on the display may be
different from the actual color.
If the reverse camera is covered with dirt, rain or
snow, an object shown on the display may be
not clear and it is required to clean the reverse
camera.
Around view monitor (AVM)*
This system can provide a 540° panoramic
image that assists the driver in viewing the
vehicle surroundings from all sides.
Through the change of field of view on all sides
and the indication of guidance lines, the relative
position and distance between the vehicle and
the obstacle can be observed to guide the driver
to drive the vehicle through the complex road or
park the vehicle safely.
Due to the vision disparity of each person,
the movement of the vehicle and different
shapes of obstacles, the distance seen
visually on the display may be different from
the actual distance.
To Next Page
Loading...