Turn signal lamps, brake lamps and headlamps
are important to driving safety. Check whether
the lamps are in good condition every time
before driving.
Usually, it is necessary to remove other related
parts before replacing a bulb, and some bulbs
can only be replaced via operation in the engine
compartment, which is very complex and
requires expertise and tools. In this case, it is
recommended to visit an authorized dealer for
bulb replacement.
● The bulb may be at high temperature
when it just goes out, so wait for the bulb
to cool down before replacing it.
● Do not touch the bulb directly with a hand.
Instead, wrap it in a piece of lint-free cloth
to avoid affecting the lighting.
● Do not touch the glass cover or inner of
reflector with hand while replacing the
bulb.
● Use the bulb with the same model and
power as the original one.
Low beam:
20.5W+8.5W
High beam: 36.45W
Position lamp/daytime
running lamp
Position lamp: 6.5W
Daytime running lamp:
27W
Fixed side: 2.4W
Movable side
(optional): 2W
Fixed side (one
on each side)
+ middle
through-type
tail lamp
Fixed side: 4.7W
Movable side: 7.4W
Rear high-mounted stop lamp
To Next Page
Loading...