Adjustment before driving
Preparation before driving
Passenger’s window regulator switch
Depending on the vehicle configuration, other
windows on some models also allow express-up
& down and anti-pinch function.
The passenger’s window regulator switch is
operated in the same way as the driver’s window
regulator switch.
When being deactivated by the driver’s power
window master switch, the passenger’s window
regulator switches will not work.
Automatic UP/DOWN*
After the vehicle power is switched off,
convenient automatic lifting/lowering of windows
can be realized by the smart key and the request
switch. (See page 11 for details)
Autoclose @ rain*
When the ENGINE START/STOP button is
turned off for 6 hours, the vehicle power supply
is in the “OFF” position and the vehicle is locked,
if the rain/light sensor on the front windshield
monitors continuous rain, the system will
automatically close the windows; when the
ENGINE START/STOP button is turned off for 6
hours, the vehicle power supply is in OFF
position and the vehicle is locked, the windows
will automatically close regardless of rain.
Setting of Autoclose @ rain
Enter “CarCenter” – “Body setting” – “Window
and roof” – “Autoclose @ rain” on the MP5
display, and use the slider on the right side to
turn on or off the Autoclose @ rain.
INTELL WINDOW LOCK*
In the “CarCenter” – “Body setting” – “Window
and roof” – “INTELL WINDOW LOCK” column
on the MP5 display, it can be set that the window
status is automatically adjusted (lifted/slit
reserved/function off) after the doors are locked.
Window power delay*
Within 30 s after the ENGINE START/STOP
button is switched from “ON” position to “OFF”
position, the windows can be lifted or lowered by
pressing the window regulator switches. For the
vehicle model without anti-pinch function, the
window power delay function will be deactivated
when the door is opened.
Anti-pinch function*
In case of any obstacle during window lifting, the
window will lower to some extent and then stop.
Initializing automatic UP/DOWN and anti-
pinch function
If the battery is disconnected and then
reconnected or the window express-up and
down and anti-pinch functions fail, the power
window needs to be initialized;
1. Lift the window regulator switch to allow the
window to stop in the position where more than
half UP travel has been completed;
2. Lift the window regulator switch to lift the
window to the limit and keep the state for 5s;
3. Press and hold the switch to lower the window
to the limit and keep the state for 5s. Afterwards,
the initialization is completed.
To Next Page
Loading...