C
HAPTER
6
| VLAN Configuration
Protocol VLANs
– 178 –
WEB INTERFACE
To map a protocol group to a VLAN for a port or trunk:
1. Click VLAN, Protocol.
2. Select Configure Interface from the Step list.
3. Select Add from the Action list.
4. Select a port or trunk.
5. Enter the identifier for a protocol group.
6. Enter the corresponding VLAN to which the protocol traffic will be
forwarded.
7. Click Apply.
Figure 74: Assigning Interfaces to Protocol VLANs
To show the protocol groups mapped to a port or trunk:
1. Click VLAN, Protocol.
2. Select Configure Interface from the Step list.
3. Select Show from the Action list.
Figure 75: Showing the Interface to Protocol Group Mapping
To Next Page
Loading...
Need help?
General