C
HAPTER
21
| System Management Commands
Line
– 521 –
COMMAND MODE
Global Configuration
COMMAND USAGE
Telnet is considered a virtual terminal connection and will be shown as
“VTY” in screen displays such as show users. However, the serial
communication parameters (e.g., databits) do not affect Telnet
connections.
EXAMPLE
To enter console line mode, enter the following command:
Console(config)#line console
Console(config-line)#
RELATED COMMANDS
show line (529)
show users (507)
databits This command sets the number of data bits per character that are
interpreted and generated by the console port. Use the no form to restore
the default value.
SYNTAX
databits {7 | 8}
no databits
7 - Seven data bits per character.
8 - Eight data bits per character.
DEFAULT SETTING
8 data bits per character
COMMAND MODE
Line Configuration
COMMAND USAGE
The databits command can be used to mask the high bit on input from
devices that generate 7 data bits with parity. If parity is being generated,
specify 7 data bits per character. If no parity is required, specify 8 data bits
per character.
EXAMPLE
To specify 7 data bits, enter this command:
Console(config-line)#databits 7
Console(config-line)#
To Next Page
Loading...
Need help?
General