C
HAPTER
24
| Authentication Commands
Telnet Server
– 607 –
TELNET SERVER
This section describes commands used to configure Telnet management
access to the switch.
N
OTE
:
This switch also supports a Telnet client function. A Telnet connection
can be made from this switch to another device by entering the telnet
command at the Privileged Exec configuration level.
ip telnet max-
sessions
This command specifies the maximum number of Telnet sessions that can
simultaneously connect to this system. Use the no from to restore the
default setting.
SYNTAX
ip telnet max-sessions session-count
no ip telnet max-sessions
session-count - The maximum number of allowed Telnet session.
(Range: 0-4)
DEFAULT SETTING
4 sessions
COMMAND MODE
Global Configuration
COMMAND USAGE
A maximum of four sessions can be concurrently opened for Telnet and
Secure Shell (i.e., both Telnet and SSH share a maximum number or four
sessions).
EXAMPLE
Console(config)#ip telnet max-sessions 1
Console(config)#
Table 68: Telnet Server Commands
Command Function Mode
ip telnet max-sessions Specifies the maximum number of Telnet sessions that
can simultaneously connect to this system
GC
ip telnet port Specifies the port to be used by the Telnet interface GC
ip telnet server Allows the switch to be monitored or configured from
Telnet
GC
show ip telnet Displays configuration settings for the Telnet server PE
To Next Page
Loading...
Need help?
General