C
HAPTER
24
| Authentication Commands
Web Server
– 605 –
ip http secure-
server
This command enables the secure hypertext transfer protocol (HTTPS) over
the Secure Socket Layer (SSL), providing secure access (i.e., an encrypted
connection) to the switch’s web interface. Use the no form to disable this
function.
SYNTAX
[no] ip http secure-server
DEFAULT SETTING
Enabled
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† Both HTTP and HTTPS service can be enabled independently on the
switch. However, you cannot configure the HTTP and HTTPS servers to
use the same UDP port.
â—† If you enable HTTPS, you must indicate this in the URL that you specify
in your browser: https://device[:port_number]
â—† When you start HTTPS, the connection is established in this way:
â–
The client authenticates the server using the server’s digital
certificate.
â–
The client and server negotiate a set of security protocols to use for
the connection.
â–
The client and server generate session keys for encrypting and
decrypting data.
â—† The client and server establish a secure encrypted connection.
A padlock icon should appear in the status bar for Internet Explorer 5.x
or above, Netscape Navigator 6.2 or above, and Mozilla Firefox 2.0.0.0
or above.
The following web browsers and operating systems currently support
HTTPS:
Table 67: HTTPS System Support
Web Browser Operating System
Internet Explorer 5.0 or later Windows 98,Windows NT (with service pack 6a),
Windows 2000, Windows XP, Windows Vista, Windows 7
Netscape Navigator 6.2 or
later
Windows 98,Windows NT (with service pack 6a),
Windows 2000, Windows XP, Solaris 2.6
Mozilla Firefox 2.0.0.0 or later Windows 2000, Windows XP, Linux
To Next Page
Loading...
Need help?
General