C
HAPTER
27
| Interface Commands
– 711 –
Speed-duplex : Auto
Capabilities : 10half, 10full, 100half, 100full
Broadcast Storm : Enabled
Broadcast Storm Limit : 500 packets/second
Multicast Storm : Disabled
Multicast Storm Limit : 64 Kbits/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 64 Kbits/second
Flow Control : Disabled
LACP : Disabled
Mac-Learning : Yes
Port Security : Disabled
Max MAC Count : 0
Port Security Action : None
Media Type : Copper forced
Current Status:
Link Status : Up
Port Operation Status : Up
Operation Speed-duplex : 100full
Flow Control Type : None
Console#
show interfaces
switchport
This command displays the administrative and operational status of the
specified interfaces.
SYNTAX
show interfaces switchport [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
DEFAULT SETTING
Shows all interfaces.
COMMAND MODE
Normal Exec, Privileged Exec
COMMAND USAGE
If no interface is specified, information on all interfaces is displayed.
EXAMPLE
This example shows the configuration setting for port 1.
Console#show interfaces switchport ethernet 1/1
Information of Eth 1/1
Broadcast Threshold : Enabled, 500 packets/second
Multicast Threshold : Disabled
Unknown Unicast Threshold : Disabled
LACP Status : Disabled
Ingress Rate Limit : Disabled, 1000M bits per second