C
HAPTER
21
| System Management Commands
Line
– 527 –
supported. If you select the “auto” option, the switch will automatically
detect the baud rate configured on the attached terminal, and adjust the
speed accordingly.
EXAMPLE
To specify 57600 bps, enter this command:
Console(config-line)#speed 57600
Console(config-line)#
stopbits This command sets the number of the stop bits transmitted per byte. Use
the no form to restore the default setting.
SYNTAX
stopbits {1 | 2}
no stopbits
1 - One stop bit
2 - Two stop bits
DEFAULT SETTING
1 stop bit
COMMAND MODE
Line Configuration
EXAMPLE
To specify 2 stop bits, enter this command:
Console(config-line)#stopbits 2
Console(config-line)#
timeout login
response
This command sets the interval that the system waits for a user to log into
the CLI. Use the no form to restore the default setting.
SYNTAX
timeout login response [seconds]
no timeout login response
seconds - Integer that specifies the timeout interval.
(Range: 0 - 300 seconds; 0: disabled)
DEFAULT SETTING
CLI: Disabled (0 seconds)
Telnet: 300 seconds
To Next Page
Loading...
Need help?
General