C
HAPTER
7
| Address Table Settings
Changing the Aging Time
– 188 –
4. Click Apply.
Figure 83: Configuring Static MAC Addresses
To show the static addresses in MAC address table:
1. Click MAC Address, Static.
2. Select Show from the Action list.
Figure 84: Displaying Static MAC Addresses
CHANGING THE AGING TIME
Use the MAC Address > Dynamic (Configure Aging) page to set the aging
time for entries in the dynamic address table. The aging time is used to
age out dynamically learned forwarding information.
CLI REFERENCES
â—† "mac-address-table aging-time" on page 753
PARAMETERS
These parameters are displayed:
◆ Aging Status – Enables/disables the function.
◆ Aging Time – The time after which a learned entry is discarded.
(Range: 10-844 seconds; Default: 300 seconds)
To Next Page
Loading...
Need help?
General