C
HAPTER
14
| Security Measures
Access Control Lists
– 304 –
CONFIGURING A
STANDARD IPV4 ACL
Use the Security > ACL (Configure ACL - Add Rule - IP Standard) page to
configure a Standard IPv4 ACL.
CLI REFERENCES
◆ "permit, deny (Standard IP ACL)" on page 685
◆ "show ip access-list" on page 689
◆ "Time Range" on page 545
PARAMETERS
These parameters are displayed:
◆ Type – Selects the type of ACLs to show in the Name list.
◆ Name – Shows the names of ACLs matching the selected type.
◆ Action – An ACL can contain any combination of permit or deny rules.
◆ Address Type – Specifies the source IP address. Use “Any” to include
all possible addresses, “Host” to specify a specific host address in the
Address field, or “IP” to specify a range of addresses with the Address
and Subnet Mask fields. (Options: Any, Host, IP; Default: Any)
◆ Source IP Address – Source IP address.
◆ Source Subnet Mask – A subnet mask containing four integers from 0
to 255, each separated by a period. The mask uses 1 bits to indicate
“match” and 0 bits to indicate “ignore.” The mask is bitwise ANDed with
the specified source IP address, and compared with the address for
each IP packet entering the port(s) to which this ACL has been
assigned.
◆ Time Range – Name of a time range.
WEB INTERFACE
To add rules to a Standard IP ACL:
1. Click Security, ACL.
2. Select Configure ACL from the Step list.
3. Select Add Rule from the Action list.
4. Select Standard IP from the Type list.
5. Select the name of an ACL from the Name list.
6. Specify the action (i.e., Permit or Deny).
7. Select the address type (Any, Host, or IP).
8. If you select “Host,” enter a specific address. If you select “IP,” enter a
subnet address and the mask for an address range.
To Next Page
Loading...
Need help?
General