C
HAPTER
14
| Security Measures
Web Authentication
– 276 –
Figure 152: Configuring Global Settings for Web Authentication
CONFIGURING
INTERFACE SETTINGS
FOR WEB
AUTHENTICATION
Use the Security > Web Authentication (Configure Interface) page to
enable web authentication on a port, and display information for any
connected hosts.
CLI REFERENCES
â—† "Web Authentication" on page 654
PARAMETERS
These parameters are displayed:
◆ Port – Indicates the port being configured.
◆ Status – Configures the web authentication status for the port.
◆ Host IP Address – Indicates the IP address of each connected host.
◆ Remaining Session Time – Indicates the remaining time until the
current authorization session for the host expires.
◆ Apply – Enables web authentication if the Status box is checked.
◆ Re-authenticate – Ends all authenticated web sessions for selected
host IP addresses in the Authenticated Host List, and forces the users
to re-authenticate.
WEB INTERFACE
To enable web authentication for a port:
1. Click Security, Web Authentication.
2. Select Configure Interface from the Step list.
3. Set the status box to enabled for any port that requires web
authentication, and click Apply
4. Mark the check box for any host addresses that need to be re-
authenticated, and click Re-authenticate.
To Next Page
Loading...
Need help?
General