C
HAPTER
21
| System Management Commands
Line
– 523 –
DEFAULT SETTING
login local
COMMAND MODE
Line Configuration
COMMAND USAGE
â—† There are three authentication modes provided by the switch itself at
login:
â–
login selects authentication by a single global password as
specified by the password line configuration command. When using
this method, the management interface starts in Normal Exec (NE)
mode.
â–
login local selects authentication via the user name and password
specified by the username command (i.e., default setting). When
using this method, the management interface starts in Normal Exec
(NE) or Privileged Exec (PE) mode, depending on the user’s
privilege level (0 or 15 respectively).
â–
no login selects no authentication. When using this method, the
management interface starts in Normal Exec (NE) mode.
â—† This command controls login authentication via the switch itself. To
configure user names and passwords for remote authentication
servers, you must use the RADIUS or TACACS software installed on
those servers.
EXAMPLE
Console(config-line)#login local
Console(config-line)#
RELATED COMMANDS
username (585)
password (524)
parity This command defines the generation of a parity bit. Use the no form to
restore the default setting.
SYNTAX
parity {none | even | odd}
no parity
none - No parity
even - Even parity
odd - Odd parity
To Next Page
Loading...
Need help?
General