EasyManuals Logo

Edge-Core ES3510MA User Manual

Edge-Core ES3510MA
984 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #765 background imageLoading...
Page #765 background image
C
HAPTER
33
| Spanning Tree Commands
– 765 –
Each bridge decrements the hop count by one before passing on the BPDU.
When the hop count reaches zero, the message is dropped.
EXAMPLE
Console(config-mstp)#max-hops 30
Console(config-mstp)#
mst priority This command configures the priority of a spanning tree instance. Use the
no form to restore the default.
SYNTAX
mst instance-id priority priority
no mst instance-id priority
instance-id - Instance identifier of the spanning tree.
(Range: 0-4094)
priority - Priority of the a spanning tree instance.
(Range: 0-61440 in steps of 4096; Options: 0, 4096, 8192, 12288,
16384, 20480, 24576, 28672, 32768, 36864, 40960, 45056,
49152, 53248, 57344, 61440)
DEFAULT SETTING
32768
COMMAND MODE
MST Configuration
COMMAND USAGE
â—† MST priority is used in selecting the root bridge and alternate bridge of
the specified instance. The device with the highest priority (i.e., lowest
numerical value) becomes the MSTI root device. However, if all devices
have the same priority, the device with the lowest MAC address will
then become the root device.
â—† You can set this switch to act as the MSTI root device by specifying a
priority of 0, or as the MSTI alternate device by specifying a priority of
16384.
EXAMPLE
Console(config-mstp)#mst 1 priority 4096
Console(config-mstp)#

Table of Contents

Other manuals for Edge-Core ES3510MA

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ES3510MA and is the answer not in the manual?

Edge-Core ES3510MA Specifications

General IconGeneral
BrandEdge-Core
ModelES3510MA
CategorySwitch
LanguageEnglish

Related product manuals