C
HAPTER
14
| Security Measures
ARP Inspection
– 320 –
WEB INTERFACE
To display statistics for ARP Inspection:
1. Click Security, ARP Inspection.
2. Select Configure Information from the Step list.
3. Select Show Statistics from the Step list.
Figure 182: Displaying Statistics for ARP Inspection
DISPLAYING THE ARP
INSPECTION LOG
Use the Security > ARP Inspection (Show Information - Show Log) page to
show information about entries stored in the log, including the associated
VLAN, port, and address components.
CLI REFERENCES
â—† "show ip arp inspection log" on page 681
PARAMETERS
These parameters are displayed:
ARP packets dropped by
additional validation
(Src-MAC)
Count of packets that failed the source MAC address test.
ARP packets dropped by ARP
ACLs
Count of ARP packets that failed validation against ARP ACL
rules.
ARP packets dropped by
DHCP snooping
Count of packets that failed validation against the DHCP
Snooping Binding database.
Table 19: ARP Inspection Statistics (Continued)
Parameter Description
Table 20: ARP Inspection Log
Parameter Description
VLAN ID The VLAN where this packet was seen.
Port The port where this packet was seen.
To Next Page
Loading...
Need help?
General