C
HAPTER
4
| Basic Management Tasks
Managing System Files
– 98 –
WEB INTERFACE
To set a file to use for system initialization:
1. Click System, then File.
2. Select Set Start-Up from the Action list.
3. Mark the operation code or configuration file to be used at startup
4. Then click Apply.
Figure 9: Setting Start-Up Files
To start using the new firmware or configuration settings, reboot the
system via the System > Reset menu.
SHOWING SYSTEM
FILES
Use the System > File (Show) page to show the files in the system
directory, or to delete a file.
N
OTE
:
Files designated for start-up, and the Factory_Default_Config.cfg
file, cannot be deleted.
CLI REFERENCES
◆ "dir" on page 515
◆ "delete" on page 515
WEB INTERFACE
To show the system files:
1. Click System, then File.
2. Select Show from the Action list.
3. To delete a file, mark it in the File List and click Delete.
To Next Page
Loading...
