Edge-Core ES3510MA - Snmp-Server Enable Port-Traps Atc Broadcast-Control-Release; Snmp-Server Enable Port-Traps Atc Multicast-Alarm-Clear

C HAPTER 31 | Automatic Traffic Control Commands
– 749 –
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-control-apply
Console(config-if)#
RELATED COMMANDS
auto-traffic-control alarm-fire-threshold (746)
auto-traffic-control apply-timer (741)
snmp-server enable
port-traps atc
broadcast-control-
release
This command sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered and the
release timer expires. Use the no form to disable this trap.
SYNTAX
[no] snmp-server enable port-traps atc
broadcast-control-release
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet)
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-control-
release
Console(config-if)#
RELATED COMMANDS
auto-traffic-control alarm-clear-threshold (745)
auto-traffic-control action (744)
auto-traffic-control release-timer (742)
snmp-server enable
port-traps atc
multicast-alarm-
clear
This command sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been triggered. Use the no
form to disable this trap.
SYNTAX
[no] snmp-server enable port-traps atc multicast-alarm-clear
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet)