C
HAPTER
22
| SNMP Commands
– 557 –
EXAMPLE
Console(config)#snmp-server
Console(config)#
snmp-server
community
This command defines community access strings used to authorize
management access by clients using SNMP v1 or v2c. Use the no form to
remove the specified community string.
SYNTAX
snmp-server community string [ro | rw]
no snmp-server community string
string - Community string that acts like a password and permits
access to the SNMP protocol. (Maximum length: 32 characters, case
sensitive; Maximum number of strings: 5)
ro - Specifies read-only access. Authorized management stations
are only able to retrieve MIB objects.
rw - Specifies read/write access. Authorized management stations
are able to both retrieve and modify MIB objects.
DEFAULT SETTING
â—† public - Read-only access. Authorized management stations are only
able to retrieve MIB objects.
â—† private - Read/write access. Authorized management stations are able
to both retrieve and modify MIB objects.
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#snmp-server community alpha rw
Console(config)#
snmp-server
contact
This command sets the system contact string. Use the no form to remove
the system contact information.
SYNTAX
snmp-server contact string
no snmp-server contact
string - String that describes the system contact information.
(Maximum length: 255 characters)
DEFAULT SETTING
None
To Next Page
Loading...
Need help?
General