C
HAPTER
27
| Interface Commands
– 700 –
interface This command configures an interface type and enter interface
configuration mode. Use the no form with a trunk to remove an inactive
interface. Use the no form with a Layer 3 VLAN (normal type) to change it
back to a Layer 2 interface.
SYNTAX
[no] interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
vlan vlan-id (Range: 1-4093)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
EXAMPLE
To specify port 4, enter the following command:
Console(config)#interface ethernet 1/4
Console(config-if)#
alias This command configures an alias name for the interface. Use the no form
to remove the alias name.
SYNTAX
alias string
no alias
string - A mnemonic name to help you remember what is attached
to this interface. (Range: 1-64 characters)
DEFAULT SETTING
None
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
To Next Page
Loading...
Need help?
General