C
HAPTER
21
| System Management Commands
Line
– 526 –
silent-time This command sets the amount of time the management console is
inaccessible after the number of unsuccessful logon attempts exceeds the
threshold set by the password-thresh command. Use the no form to
remove the silent time value.
SYNTAX
silent-time [seconds]
no silent-time
seconds - The number of seconds to disable console response.
(Range: 0-65535; 0: 30 seconds)
DEFAULT SETTING
The default value is no silent-time.
COMMAND MODE
Line Configuration
EXAMPLE
To set the silent time to 60 seconds, enter this command:
Console(config-line)#silent-time 60
Console(config-line)#
RELATED COMMANDS
password-thresh (525)
speed This command sets the terminal line’s baud rate. This command sets both
the transmit (to terminal) and receive (from terminal) speeds. Use the no
form to restore the default setting.
SYNTAX
speed bps
no speed
bps - Baud rate in bits per second.
(Options: 9600, 19200, 38400, 57600, 115200 bps, or auto)
DEFAULT SETTING
115200 bps
COMMAND MODE
Line Configuration
COMMAND USAGE
Set the speed to match the baud rate of the device connected to the serial
port. Some baud rates available on devices connected to the port might not
be supported. The system indicates if the speed you selected is not
To Next Page
Loading...
Need help?
General