C
HAPTER
15
| Basic Administration Protocols
Remote Monitoring
– 400 –
To show configured RMON events:
1. Click Administration, RMON.
2. Select Configure Global from the Step list.
3. Select Show from the Action list.
4. Click Event.
Figure 236: Showing Configured RMON Events
CONFIGURING RMON
HISTORY SAMPLES
Use the Administration > RMON (Configure Interface - Add - History) page
to collect statistics on a physical interface to monitor network utilization,
packet types, and errors. A historical record of activity can be used to track
down intermittent problems. The record can be used to establish normal
baseline activity, which may reveal problems associated with high traffic
levels, broadcast storms, or other unusual events. It can also be used to
predict network growth and plan for expansion before your network
becomes too overloaded.
CLI REFERENCES
â—† "Remote Monitoring Commands" on page 575
COMMAND USAGE
â—† Each index number equates to a port on the switch.
â—† If history collection is already enabled on an interface, the entry must
be deleted before any changes can be made.
â—† The information collected for each sample includes:
input octets, packets, broadcast packets, multicast packets, undersize
packets, oversize packets, fragments, jabbers, CRC alignment errors,
collisioins, drop events, and network utilization.
For a description of the statistics displayed on the Show Details page,
refer to "Showing Port or Trunk Statistics" on page 128.
To Next Page
Loading...
Need help?
General