C
HAPTER
21
| System Management Commands
File Management
– 518 –
â—† Any changes made to the default setting can be displayed with the
show running-config (page 505) or show startup-config (page 506)
commands.
EXAMPLE
Console(config)#upgrade opcode auto
Console(config)#upgrade opcode path tftp://192.168.0.1/sm24/
Console(config)#
If a new image is found at the specified location, the following type of
messages will be displayed during bootup.
.
.
.
Automatic Upgrade is looking for a new image
New image detected: current version 1.1.1.0; new version 1.1.1.2
Image upgrade in progress
The switch will restart after upgrade succeeds
Downloading new image
Flash programming started
Flash programming completed
The switch will now restart
.
.
.
upgrade opcode
path
This command specifies an TFTP server and directory in which the new
opcode is stored. Use the no form of this command to clear the current
setting.
SYNTAX
upgrade opcode path opcode-dir-url
no upgrade opcode path
opcode-dir-url - The location of the new code.
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† This command is used in conjunction with the upgrade opcode auto
command to facilitate automatic upgrade of new operational code
stored at the location indicated by this command.
â—† The name for the new image stored on the TFTP server must be
es3510ma.bix. However, note that file name is not to be included in this
command.
To Next Page
Loading...
Need help?
General