C
HAPTER
38
| LLDP Commands
– 887 –
EXAMPLE
Console(config)#lldp reinit-delay 10
Console(config)#
lldp tx-delay This command configures a delay between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables. Use the
no form to restore the default setting.
SYNTAX
lldp tx-delay seconds
no lldp
tx-delay
seconds - Specifies the transmit delay. (Range: 1 - 8192 seconds)
DEFAULT SETTING
2 seconds
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† The transmit delay is used to prevent a series of successive LLDP
transmissions during a short period of rapid changes in local LLDP MIB
objects, and to increase the probability that multiple, rather than single
changes, are reported in each transmission.
â—† This attribute must comply with the following rule:
(4 * tx-delay) ≤
refresh-interval
EXAMPLE
Console(config)#lldp tx-delay 10
Console(config)#
lldp admin-status This command enables LLDP transmit, receive, or transmit and receive
mode on the specified port. Use the no form to disable this feature.
SYNTAX
lldp admin-status {rx-only | tx-only | tx-rx}
no lldp admin-status
rx-only - Only receive LLDP PDUs.
tx-only - Only transmit LLDP PDUs.
tx-rx - Both transmit and receive LLDP Protocol Data Units (PDUs).
To Next Page
Loading...
Need help?
General