C
HAPTER
37
| Multicast Filtering Commands
Multicast VLAN Registration
– 880 –
show mvr This command shows information about the global MVR configuration
settings when entered without any keywords, the interfaces attached to
the MVR VLAN using the interface keyword, or the multicast groups
assigned to the MVR VLAN using the members keyword.
SYNTAX
show mvr [interface [interface] | members [ip-address]]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
ip-address - IP address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
DEFAULT SETTING
Displays global configuration settings for MVR when no keywords are used.
COMMAND MODE
Privileged Exec
COMMAND USAGE
Enter this command without any keywords to display the global settings for
MVR. Use the interface keyword to display information about interfaces
attached to the MVR VLAN. Or use the members keyword to display
information about multicast groups assigned to the MVR VLAN.
EXAMPLE
The following shows the global MVR settings:
Console#show mvr
MVR Config Status : Enabled
MVR Running Status : Active
MVR Multicast VLAN : 1
MVR Group Address : 225.0.0.5
MVR Group Count : 10
Console#
Table 126: show mvr - display description
Field Description
MVR Config Status Shows if MVR is globally enabled on the switch.
MVR Running Status Indicates whether or not all necessary conditions in the MVR
environment are satisfied. (Running status is true as long as MVR
Status is enabled, and the specified MVR VLAN exists.)
MVR Multicast VLAN Shows the VLAN used to transport all MVR multicast traffic.
To Next Page
Loading...
Need help?
General