C
HAPTER
23
| Remote Monitoring Commands
– 578 –
COMMAND USAGE
â—† If an event is already defined for an index, the entry must be deleted
before any changes can be made with this command.
â—† The specified events determine the action to take when an alarm
triggers this event. The response to an alarm can include logging the
alarm or sending a message to a trap manager.
EXAMPLE
Console(config)#rmon event 2 log description urgent owner mike
Console(config)#
rmon collection
history
This command periodically samples statistics on a physical interface. Use
the no form to disable periodic sampling.
SYNTAX
rmon collection history index [buckets number] |
[interval seconds] | [owner name]
no rmon collection history index
index – Index to this entry. (Range: 1-65535)
number – The number of buckets requested for this entry.
(Range: 1-65536)
seconds – The polling interval. (Range: 1-3600 seconds)
name – Name of the person who created this entry. (Range: 1-127
characters)
DEFAULT SETTING
Enabled
Buckets: 50
Interval: 1800 seconds
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
â—† By default, each index number equates to a port on the ECN430-swich,
but can be changed to any number not currently in use.
â—† If periodic sampling is already enabled on an interface, the entry must
be deleted before any changes can be made with this command.
â—† The information collected for each sample includes:
input octets, packets, broadcast packets, multicast packets, undersize
packets, oversize packets, fragments, jabbers, CRC alignment errors,
collisioins, drop events, and network utilization.
To Next Page
Loading...
Need help?
General