Edge-Core ES3510MA - Ddress Able Ommands; Commands; Mac-Address-Table Aging-Time; Table 98: Address Table Commands

– 753 –
32 ADDRESS TABLE COMMANDS
These commands are used to configure the address table for filtering
specified addresses, displaying current entries, clearing the table, or
setting the aging time.
mac-address-table
aging-time
This command sets the aging time for entries in the address table. Use the
no form to restore the default aging time.
SYNTAX
mac-address-table aging-time seconds
no mac-address-table aging-time
seconds - Aging time. (Range: 10-844 seconds; 0 to disable aging)
DEFAULT SETTING
300 seconds
COMMAND MODE
Global Configuration
COMMAND USAGE
The aging time is used to age out dynamically learned forwarding
information.
EXAMPLE
Console(config)#mac-address-table aging-time 100
Console(config)#
Table 98: Address Table Commands
Command Function Mode
mac-address-table
aging-time
Sets the aging time of the address table GC
mac-address-table
static
Maps a static address to a port in a VLAN GC
clear mac-address-
table dynamic
Removes any learned entries from the
forwarding database
PE
show mac-address-
table
Displays entries in the bridge-forwarding
database
PE
show mac-address-
table aging-time
Shows the aging time for the address table PE