C
HAPTER
38
| LLDP Commands
– 894 –
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv mac-phy
Console(config-if)#
lldp dot3-tlv max-
frame
This command configures an LLDP-enabled port to advertise its maximum
frame size. Use the no form to disable this feature.
SYNTAX
[no] lldp dot3-tlv max-frame
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
Refer to "Frame Size" on page 509 for information on configuring the
maximum frame size for this switch.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp dot3-tlv max-frame
Console(config-if)#
lldp notification This command enables the transmission of SNMP trap notifications about
LLDP changes. Use the no form to disable LLDP notifications.
SYNTAX
[no] lldp notification
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
â—† This option sends out SNMP trap notifications to designated target
stations at the interval specified by the lldp notification-interval
command. Trap notifications include information about state changes in
the LLDP MIB (IEEE 802.1AB), or organization-specific LLDP-EXT-DOT1
and LLDP-EXT-DOT3 MIBs.
To Next Page
Loading...
Need help?
General