C
HAPTER
18
| Multicast Filtering
Multicast VLAN Registration
– 468 –
multicast traffic from one of the MVR groups, or a multicast group has
been statically assigned to an interface.
◆ Immediate Leave – Configures the switch to immediately remove an
interface from a multicast stream as soon as it receives a leave
message for that group. (This option only applies to an interface
configured as an MVR receiver.)
WEB INTERFACE
To configure interface settings for MVR:
1. Click Multicast, MVR.
2. Select Configure Interface from the Action list.
3. Set each port that will participate in the MVR protocol as a source port
or receiver port, and optionally enable Immediate Leave on any
receiver port to which only one subscriber is attached.
4. Click Apply.
Figure 287: Configuring Interface Settings for MVR
ASSIGNING STATIC
MULTICAST GROUPS
TO INTERFACES
Use the Multicast > MVR (Configure Static Group Member) page to
statically bind multicast groups to a port which will receive long-term
multicast streams associated with a stable set of hosts.
CLI REFERENCES
◆ "mvr vlan group" on page 879
PARAMETERS
These parameters are displayed:
◆ Port – Port identifier.
◆ VLAN – VLAN identifier
◆ Group IP Address – Defines a multicast service sent to the selected
port. Multicast groups must be assigned from the MVR group range
configured on the Configure General page.
To Next Page
Loading...
